Q-sys Level One Training: Control Overview
Settings
-
+
Welcome to the Q-SYS™ Training Assessment. You are about to take the assessment for the Control Overview Training Module. Please watch the videos before attempting this assessment. You must correctly answer 80% of the questions to successfully pass this assessment.
- 1.Multiple Choice: Where will you find the Global Snapshots Bank?
- A.
In the Snapshots panel in the Left-Side Pane
- B.
In the Schematic Library under Audio Components
- C.
In the Schematic Library under Control Components
- 2.Multiple Choice: How many Global Snapshot Banks can you have in your design at a time?
- A.
1
- B.
4
- C.
Unlimited
- 3.
![]()
Check ALL that Apply: Check which of the following statements are true regarding the Snapshot Bank in the image.- A.
There is nothing saved in Snapshot 4.
- B.
Snapshot 2 and Snapshot 3 contain the same information.
- C.
Snapshot 3 is currently loaded.
- D.
Snapshot 2 is currently loaded.
- E.
Snapshot 1 is currently loaded.
- F.
Snapshot 4 is currently loaded.
- 4.Multiple Choice: How do you create a User-Defined Snapshot Bank?
- A.
Use the Plus icon in the Snapshots panel in the Left-Side Pane.
- B.
Right-click a component and select “Create Snapshot from selection”.
- C.
Drag a Snapshot Bank from the Control Components into the Schematic Library.
- 5.Check ALL that Apply: How can you add a control or a component to a User-Defined Snapshot Bank?
- A.
Drag the control or component over the Snapshot bank in the Left-Side Pane and release.
- B.
Select the control or component, click on the Plus icon in the Snapshot panel and select “Create new Snapshot Bank from selection.”
- C.
Right click any control or component and select “Create new Snapshot Bank from selection.”
- 6.Multiple Choice:Which controls will a Global Snapshot memorize?
- A.
Every control in the entire design
- B.
Every control on the same Schematic Page as the Snapshot Bank
- C.
Only the controls that have been dragged into the Snapshot Bank
- 7.Fill in the Blank:How many Snapshots can be saved in a single Snapshot bank?
- 8.Multiple Choice:How do you remove a component or control from a User-Defined Snapshot Bank?
- A.
Select the control or component icon in the Snapshot panel and press Delete.
- B.
You cannot remove a control or component from a Bank once it has been assigned to it.
- C.
Open the Snapshot Bank’s control panel and remove the control or component from it.
.jpg)
Back to top